- ページ 6

スイッチ Drehmo 384771のPDF 追加取扱説明書をオンラインで閲覧またはダウンロードできます。Drehmo 384771 12 ページ。 Simc with limit switching unit

lines up with switch and it operates, stop turning. If the cam is turned too far by mistake,

repeat the entire setting process from the beginning.

NOTICE

The signal of the potentiometer is converted into a 4 20 mA

1.3 Setting the reduction gearing for multi-turn

actuators

To reset the reduction gearing according to table 1.1, loosen the ﬁxing screw item 4 in

ﬁgure 1.3. After unfastening the screw, the sliding wheel can be moved up (smaller angle

for the mechanical position indicator) and down (larger angle for the mechanical position

indicator). As soon as the new position of the sliding wheel has been reached, fasten the

ﬁxing screw.

NOTICE

Observe correct position of the sliding wheel!

Adjust the reduction gearing to the stroke to make it run cor-

rectly

The splines of the sliding wheel must fully engage into the

counterwheel.

1. COMMISSIONING

Additional operating manual