- ページ 6

顕微鏡 Andonstar AD206SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Andonstar AD206S 11 ページ。

3. The another clip is installed in the same way.

*Install main device: Loosen the small thumbscrews on the optical bracket. Then slide the optical stack

in to the ring of the optical bracket. Finally tighten the thumbscrews to hold the optical stack in place.

If done correctly,

but also freely adjust the monitor,

rest of microscope remains in place.

*Connect the power supply: connect the microscope and the power supply with the switch cable. (See

Figure 6)

you should be able to not just turn the focus controller of the optical stack freely,

the angle between the base and the optical bracket,

If you have any question or problem for assembly,

so you won't damage the device during assembly.

（ Figure 6 Connect ）

（ Figure7 Remote buttons ）

while the

please