- ページ 10

ラック＆スタンド andover Model-OneのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。andover Model-One 14 ページ。 Modular stand system
andover Model-One にも： 製品マニュアル (19 ページ), 製品マニュアル (8 ページ)

ページを印刷する
andover Model-One 製品マニュアル
Back Panel
Power Inlet

Making the Initial Connections

1. Connect the power cord into the AC power input connector and plug the
other end into a grounded wall outlet.
2. Connect an RCA cable from the Subwoofer output of the source component
into the RCA jack input.
3. Switch the power switch adjacent to the AC input ON.
4. Switch the Power mode switch to the AUTO (middle) position.
If using the Model-One Turntable music system, set the Volume and Frequency
knobs to their center detent position. This is our factory-recommended setting.
Once the system is installed and operating, you may freely adjust these controls
to your taste.
The LED adjacent to the Power Mode switch indicates operating status. A Red
LED indicates the subwoofer is on and in Standby. When a signal is present,
the LED will turn green and the subwoofer will be active. After a few minutes of
silence, the woofer will return to Standby.
Power
Power Mode
Page 10
Input (RCA) Volume Low Pass