andover Model-One Instrukcja obsługi produktu - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Stojaki i stojaki andover Model-One. andover Model-One 14 stron. Modular stand system
Również dla andover Model-One: Instrukcja obsługi produktu (19 strony), Instrukcja obsługi produktu (8 strony)
Drukuj stronę
Back Panel
Power Inlet
Making the Initial Connections
1. Connect the power cord into the AC power input connector and plug the
other end into a grounded wall outlet.
2. Connect an RCA cable from the Subwoofer output of the source component
into the RCA jack input.
3. Switch the power switch adjacent to the AC input ON.
4. Switch the Power mode switch to the AUTO (middle) position.
If using the Model-One Turntable music system, set the Volume and Frequency
knobs to their center detent position. This is our factory-recommended setting.
Once the system is installed and operating, you may freely adjust these controls
to your taste.
The LED adjacent to the Power Mode switch indicates operating status. A Red
LED indicates the subwoofer is on and in Standby. When a signal is present,
the LED will turn green and the subwoofer will be active. After a few minutes of
silence, the woofer will return to Standby.
Power
Power Mode
Page 10
Input (RCA) Volume Low Pass