- ページ 12

換気フード Electrolux CH60のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Electrolux CH60 21 ページ。 Cooker hood
Electrolux CH60 にも：取扱説明書 (21 ページ)

ページを印刷する

Clearance Heights

The cooker hood is designed to be fitted over a

cooking appliance at the clearance heights stated,

providing the maximum output of the appliance

beneath does not exceed the maximums quoted

in the Technical Specifications.

If the output of the appliance below the cooker

hood exceeds the maximum outputs quoted,

please refer to the cooker manufacturer's

installation instructions.

A minimum clearance height of 650mm (25 ins) is

required when installed above a built-in electric

hob, or 700mm (25 ins) when installed above a

built-in gas hob.

A minimum clearance height of 685mm (27 ins) is

required when installing above a slot-in electric

cooker, or 787mm (30 ins) when installed above a

slot-in cooker.

When installed between adjoining wall cabinets,

the wall cabinets must not overhang the hob and

the distance between the underside of the cabinet

and the worktop must be 450mmm (17 ins), a gap

of 50mm (2 ins) must be maintained either side of

the hob.

This cooker hood must not be installed

above a cooking appliance with a high

level grill.

Fitting the Wall Brackets

Draw a vertical line on the wall, from the

centre of the cooking appliance up to the

ceiling, using a spirit level and marker

pen. This is to ensure the correct vertical

alignment of the appliance.

Fixing the wall bracket No 1

Draw two horizontal lines through the

vertical at 225 and 265mm as illustrated.

Place the top edge of the bracket against

the 265mm line, aligning the centre of the

bracket with the vertical line. The line at

should run through the centre of the

keyholes. If, the alignment is correct mark

the centres for the key hole bracket fixing

screws (not supplied) as illustrated in Fig.

Ensure that the distance between the

lowest point of the hood and the cooking

appliance beneath meet the clearance

requirements quoted above.

Ensure the lower bracket 1 is fitted with

the flat top pointing away from the wall.

Fig.3