- ページ 13

換気フード Electrolux EFA90245XのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Electrolux EFA90245X 21 ページ。 Electrolux cooker hood
Electrolux EFA90245X にも：インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (16 ページ)

ページを印刷する

The clereance height between the inferior part of

the cooker hood and the hob must be 650 mm (

some models can be fitted at a lower height from

the hob, please refer to the installation paragraph).

Drilling the Ceiling/Support Shelf

• Use a plumb line to mark the centre of the hob on the

ceiling/support shelf.

• Place the drilling template 21 provided on the ceiling/

support shelf, making sure that the template is in the

correct position by lining up the axes of the template

with those of the hob.

• Mark the centres of the holes in the template.

• Drill the holes at the points marked:

• For concrete ceilings, drill for plugs appropriate to

the screw size.

• For hollow brick ceilings with wall thickness of 20

mm: drill ø 10 mm (immediately insert the Dowels

not provided).

• For wooden beam ceilings, drill according to the

wood screws used.

• For wooden shelf, drill ø 7 mm.

• For the power supply cable feed, drill ø 10 mm.

• For the air outlet (Ducted Version), drill according

to the diameter of the external air exhaust duct

connection.

• Insert two screws of the following type, crossing them

and leaving 4-5 mm from the ceiling:

• For concrete ceilings, use the appropriate plugs for

the screw size (not provided).

• For Cavity ceiling with inner space, with wall thickness

of approx. 20 mm, Screws not provided.

• For wooden beam ceilings, use 4 wood screws (not

provided).

• For wooden shelf, use 4 screws with washers and

nuts (not provided)

Fixing the Frame

• Loosen the two screws fastening the lower chimney

and remove this from the lower frame.

• Loosen the two screws fastening the upper chimney

and remove this from the upper frame.

If you wish to adjust the height of the frame, proceed

as follows:

• Unfasten the eight metric screws joining the two

columns, located at the sides of the frame.

• Adjust the frame to the height required, then replace

all the screws removed as above.

• Insert the upper chimney stack from above, and leave

it running free on the frame.

• Lift up the frame, fit the frame slots onto the screws

up to the slot end positions.

• Tighten the two screws and fasten the other two screws

provided with the hood.

INSTALLING THE COOKER HOOD

�