除湿機 Dri-Eaz DrizAir 1200のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dri-Eaz DrizAir 1200 4 ページ。 110v/50hz portable dehumidifier
Dri-Eaz DrizAir 1200 にも：オーナーズマニュアル (13 ページ), オーナーズマニュアル (5 ページ), オーナーズマニュアル (18 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (19 ページ)

ページを印刷する

Owner's Manual – DrizAir Dehumidifiers

Fax US: (360) 757-7950 Phone US: (360) 757-7776 Phone UK: (01908) 611211

DrizAir Dehumidifiers are commercial refrigerant dehumidifiers, designed for drying building structures

and contents. They are designed for high performance water removal, as well as durability and ease of use.

Safety Information

Keep Children Away: Do not allow children to play with or

around the unit, which could result in injury. Be sure the unit

is inaccessible to children when not attended.

Keep Unit Grounded: Always operate the unit with a

grounding plug and a grounded electrical outlet. A grounding

plug is an essential safety feature that helps reduce the risk

of shock or fire.

Protect Power Cord from Damage: Never operate a unit

with a damaged power cord, as this may lead to electrical or

fire hazards. If the power supply cord is damaged, it must be

replaced by a cord of the same type and amperage rating.

Extension Cords: Extension cords must be grounded and

able to deliver the appropriate voltage to the unit.

Handle With Care: Do not drop or throw the unit. Rough

treatment can damage the components or wiring and create

a hazardous condition.

Run on Stable Surface: Always operate the unit on a sta-

ble, level surface, like the floor or a strong counter, so it can-

not fall and cause injury.

Secure During Transport: When transporting in a vehicle,

secure the unit to prevent sliding and possible injury to vehi-

cle occupants.

Keep Out of Water: Never operate the unit in pooled or

standing water, as this may create a risk of injury from elec-

trical shock. Do not store or operate outdoors. If electrical

wiring or components become wet, thoroughly dry them be-

fore using the unit.

Keep Air Intakes Clear: Do not clog or block air intakes, as

may occur if operated to close to draperies or similar materi-

als. This may cause the unit to overheat and result in a fire or

electrical hazard.

Keep Filter Clean: Always use a clean air filter. Do not allow

any material to clog the filter, as this may cause the dehu-

midifier to overheat. Do not allow oil, grease, or other con-

taminants to be drawn into the dehumidifier.

Keep Electrical Components Dry: Never allow water inside

the dehumidifier's electrical components. If these areas be-

come wet for any reason, thoroughly dry them before using

the dehumidifier.

Allow Repair Only by Authorized Service Technician: Do

not attempt to disassemble or repair the unit if you are not

qualified to do so. You may handle some maintenance and

troubleshooting, but make sure that more complex problems

are handled by an authorized service technician. For infor-

mation about authorized repair, call Dri-Eaz at (360) 757-

7776 in the US, or (01908) 611211 in the UK.

07-00212 J 7-02

DrizAir 1200 and DrizAir 2000

230-volt models

DRI-EAZ PRODUCTS, INC.

15180 Josh Wilson Road, Burlington, WA USA 98233

Read And Save These Instructions

HOW TO USE DEHUMIDIFIERS

DrizAir Dehumidifiers are designed to reduce water vapor or

high humidity in a building or part of a building. The purpose

is to prevent humidity damage, and to dry out wet materials

such as carpet, carpet cushion, floors, walls, furniture, con-

tents, lumber, and structural materials.

To speed up the rate of evaporation, and dry out materials

faster, use Dri-Eaz TurboDryer airmovers. The DrizAir De-

humidifier will be needed to remove the additional water

evaporated by the TurboDryers.

Positioning Dehumidifiers

The dehumidifier must be operated in an enclosed area to

achieve best efficiency. Close all openings to other areas of

the building, like windows and doors, to prevent moist air

from mixing with the air in the drying area. Keep traffic

through doors at a minimum. This forms a closed drying

chamber.

Inside the drying chamber, air should circulate freely. Open

interior doors and operate TurboDryer airmovers to maintain

good airflow to all areas.

Place the dehumidifier where there is no restriction to air

flowing through either the inlet or the outlet. Keep away from

loose materials like curtains and drapes.

Under normal circumstances, place the dehumidifier in the

center of the room. To dry a specific area, place the dehu-

midifier so the outlet air points at the wet area and the warm,

dry air passes across it. The duct should never be closer

than three feet from the wall.

The DrizAir Dehumidifier warms the air as it removes its

moisture. In smaller rooms this can raise the temperature

substantially. Room temperatures of about 20° to 27° C (68°

to 80° F) are usually a good condition for drying. Never allow

the room temperature to exceed 38° C (100° F), because

this could damage the dehumidifier or building contents.

OPERATING INSTRUCTIONS

1. Operate the DrizAir Dehumidifier only in the upright posi-

tion. If it has been in a horizontal position for any time

over a few minutes, let it sit in the upright position for at

least 30 minutes before starting. This allows oil to drain

back into the compressor, increasing its life.

2. Plug in to a standard outlet with the correct voltage and

amperage for the unit. Push the ON switch. Listen for

proper operation of fan and compressor before leaving

the unit unattended.

3. Allow five minutes before restarting after the unit

shuts off for any reason. This will avoid damaging the

compressor.

4. If your unit has a pump, run the pump drain hose into a

sink, toilet, drain, or bucket. Make sure the hose is not

kinked. If using a bucket, check and empty the bucket