16 | English
Hold the machine only by the insulated grip-
ping surfaces, when performing an opera-
tion where the cutting tool may run into hid-
den wiring. Contact with a "live" wire will
make exposed metal parts of the tool "live"
and shock the operator.
Hold the machine with a firm grip. High re-
action torque can briefly occur while driving
in and loosening screws.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
Take protective measures when dust can
develop during working that is harmful to
one's health, combustible or explosive. Ex-
ample: Some dusts are regarded as carcino-
genic. Wear a dust mask and work with
dust/chip extraction when connectable.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Avoid unintentional switching on. Ensure
the On/Off switch is in the off position be-
fore inserting battery pack. Carrying the
power tool with your finger on the On/Off
switch or inserting the battery pack into
power tools that have the switch on invites
accidents.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e. g.,
also against continuous sun irradia-
tion and fire. There is danger of explo-
sion.
In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints. The vapours can irritate the
respiratory system.
2 609 932 590 | (26.6.07)
When the battery is defective, liquid can es-
cape and come into contact with adjacent
components. Check any parts concerned.
Clean such parts or replace them, if required.
Functional Description
Read all safety warnings and all in-
structions.
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The power tool is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Screwdriver bit*
2 Tool holder
3 Locking sleeve
4 Torque presetting ring
5 Soft grip
6 Rotational direction switch
7 On/Off switch
8 Battery unlocking button
9 Battery*
10 LED
11 Drill bit with hexagon shank*
12 Utility clip*
13 Craftsman case*
*The accessories illustrated or described are not in-
cluded as standard delivery.
Failure to follow the
Bosch Power Tools
ページを印刷する