モニター ADVANCED Network Devices IPSIGNL-RWBのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。ADVANCED Network Devices IPSIGNL-RWB 2 ページ。 Clock

Installation Instructions

The following instructions should be followed for stainless steel clock

installations.

1. A ferrite is included if there is concern over line performance. Wrap Cat 5 cable around

ferrite once and clamp shut.

2. Remove Phillips head screws from both sides of the device. (4 total)

3. Separate stainless steel baffle from wall mount bracket.

4. Mount bracket to wall using appropriate mounting hardware; see included template for

detailed instructions or use wall bracket as a guide. Use a minimum of 4 mounting holes.

5. Connect a network cable (Cat 5 or better) to the internal circuit board and connect any

additional wiring to the stainless steel unit as needed.

6. Re-insert stainless steel baffle into wall mount bracket.

7. Replace 4 screws into sides of the device.

8. Connect the other end of the network cable to a PoE (Power over Ethernet) network switch,

or a PoE injector, on a network with a DHCP server. Some equipment options are listed on

the support site: www.anetdsupport.com/peripherals.

9. If properly installed, the unit should boot and show the time within 30 seconds. See Boot

Sequence on other page for details.

10. Consult the

Clockwise User manual

software guide for further instructions on sending audio and text to the device.

Clock Installation Instructions

(IPCSS-RWB/IPCSL-RWB/IPSIGNL-RWB)

(see www.anetdsupport.com/documents) or 3

Typical model shown

For additional support, visit

www.anetdsupport.com

Version 1.5

4/20/2015

party