- ページ 8

ソウ Drill Master 61204のPDF 取扱説明書と安全上のご注意をオンラインで閲覧またはダウンロードできます。Drill Master 61204 16 ページ。 120 volt 6" cut-off saw
Drill Master 61204 にも：取扱説明書と安全上のご注意 (16 ページ)

ページを印刷する

note: Two Adapters are supplied with this saw,

5/8" (61) and 7/8" (62). The Adapter used for the

old wheel may be the wrong size for the new wheel.

Use the Adapter that fits the new Grinding Wheel.

inner Flange

Spindle with

no adapter

7/8" adapter

Figure c: adapters

7. The Adapter should be on the Spindle and

against the Inner Flange. Install the new

Grinding Wheel onto the Adapter.

8. Replace the Outer Flange onto the Spindle;

thread the Arbor Bolt onto the Spindle and

tighten them in place with the Sleeve Wrench.

adjusting cut angle

1. To cut at various angles (up to 45º),

adjust the Angle Guide by loosening the two

Bolts that attach the Guide to the Base.

2. Adjust the Angle Guide to the desired

setting and then tighten both Bolts.

3. To reposition the Angle Guide for a different-

sized workpiece, remove both of the Bolts,

and reattach the Angle Guide at the other

set of screw holes. See Figure D.

Page 8

5/8" adapter

For technical questions, please call 1-888-866-5797.

9. For wheels with paper gaskets (blotters) or

metal gaskets: Slip the grinding wheel onto the

Arbor with the gasket first. The gasket should be

centered on the grinding wheel and the wheel and

gasket should rest flat against the Inner Flange.

WarninG: to prevent serious injury, gaskets

must be used for all grinding wheels they are

provided with. Gaskets help prevent grinding wheel

damage and wheel slippage, causes of wheel failure.

10. Lower the Housing and replace the Safety Chain.

angle

Guide

Screw Holes

Figure D: repositioning the angle Guide

Bolt

(hidden)

Bolt

61204