Drill Master 61204 사용 설명서 및 안전 지침 - 페이지 8
{카테고리_이름} Drill Master 61204에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Drill Master 61204 16 페이지. 120 volt 6" cut-off saw
Drill Master 61204에 대해서도 마찬가지입니다: 사용 설명서 및 안전 지침 (16 페이지)
페이지 인쇄
note: Two Adapters are supplied with this saw,
5/8" (61) and 7/8" (62). The Adapter used for the
old wheel may be the wrong size for the new wheel.
Use the Adapter that fits the new Grinding Wheel.
inner Flange
Spindle with
no adapter
7/8" adapter
Figure c: adapters
7. The Adapter should be on the Spindle and
against the Inner Flange. Install the new
Grinding Wheel onto the Adapter.
8. Replace the Outer Flange onto the Spindle;
thread the Arbor Bolt onto the Spindle and
tighten them in place with the Sleeve Wrench.
adjusting cut angle
1. To cut at various angles (up to 45º),
adjust the Angle Guide by loosening the two
Bolts that attach the Guide to the Base.
2. Adjust the Angle Guide to the desired
setting and then tighten both Bolts.
3. To reposition the Angle Guide for a different-
sized workpiece, remove both of the Bolts,
and reattach the Angle Guide at the other
set of screw holes. See Figure D.
Page 8
5/8" adapter
For technical questions, please call 1-888-866-5797.
9. For wheels with paper gaskets (blotters) or
metal gaskets: Slip the grinding wheel onto the
Arbor with the gasket first. The gasket should be
centered on the grinding wheel and the wheel and
gasket should rest flat against the Inner Flange.
WarninG: to prevent serious injury, gaskets
must be used for all grinding wheels they are
provided with. Gaskets help prevent grinding wheel
damage and wheel slippage, causes of wheel failure.
10. Lower the Housing and replace the Safety Chain.
angle
Guide
Screw Holes
Figure D: repositioning the angle Guide
Bolt
(hidden)
Bolt
61204