- ページ 5

スピーカー Bose 141のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose 141 10 ページ。 Bose 141: owners guide
Bose 141 にも：オーナーズマニュアル (9 ページ)

Check the connections

Check to be sure all connections are made positive to positive (+ to +) and negative to

negative (– to –). Make sure that no loose strands of wire touch across terminals. Bridged

wires can short circuit and damage the speaker components. Tighten any loose connec-

tions before you plug in the receiver or amplifier and turn it on.

–

To make sure your speakers operate correctly:

1. Set your receiver or amplifier to MONO (monophonic) and turn it on.

2. Set the balance control to normal (center position).

3. Place the speakers less than 6 inches (15 cm) apart, facing each other.

4. Play some deep bass passages of music through the speaker.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, your connections may be out of phase. To make them match

connections to the amplifier, try reversing the + and – connections on the back of one

speaker. Then repeat steps 1 – 4.

AM182344_04_V.pdf

Amplifier or receiver

– +

–

October 30, 2001

Setting Up

Figure 3

Completed connections