Bose 141 Kullanıcı El Kitabı - Sayfa 5

Konuşmacılar Bose 141 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose 141 10 sayfaları. Bose 141: owners guide
Ayrıca Bose 141 için: Kullanıcı El Kitabı (9 sayfalar)

Sayfayı Yazdır
Bose 141 Kullanıcı El Kitabı

Check the connections

Check to be sure all connections are made positive to positive (+ to +) and negative to
negative (– to –). Make sure that no loose strands of wire touch across terminals. Bridged
wires can short circuit and damage the speaker components. Tighten any loose connec-
tions before you plug in the receiver or amplifier and turn it on.
+
–

Test the speakers

To make sure your speakers operate correctly:
1. Set your receiver or amplifier to MONO (monophonic) and turn it on.
2. Set the balance control to normal (center position).
3. Place the speakers less than 6 inches (15 cm) apart, facing each other.
4. Play some deep bass passages of music through the speaker.
The sound should seem to come from a point between the two speakers. The bass should
be full and natural. If it is not, your connections may be out of phase. To make them match
connections to the amplifier, try reversing the + and – connections on the back of one
speaker. Then repeat steps 1 – 4.
AM182344_04_V.pdf
Amplifier or receiver
– +
–
+
–
+
October 30, 2001
Setting Up
Figure 3
Completed connections
5