B
S
ASIC
YSTEM
Cube speakers connect to the Acoustimass
Jewel Cube speakers
Figure 8
Making a plug-in cable
connection
12
C
ONNECTIONS
Each LIFESTYLE
®
DVD system includes five cube speakers. Use the supplied 20-foot
(6.1-meters) cable to connect the three speakers arranged at the front of your room. Use the
supplied 50-foot (15.2-meter) cables for your surround speakers, pulling the cables apart to
run them in different directions around your room.
Your system may feature Jewel Cube
Follow the instructions below for connecting them. Or, you may have cube arrays or single
cube speakers, which use a two-wire cable for connections. Instructions for connecting them
appear on page 13.
CAUTION: Before you make any connections, be sure that the media center, the Acoustimass
module, and any additional equipment are NOT connected to AC power.
Connecting the plug-in cable to Jewel Cube
The plug-in cable for your speakers fit only one way into the jack, which ensures proper
polarity (+ to + and – to –) connections.
1. Match each cable, according to its location marking, with the speaker placed in that
location:
• Front speaker cables have blue RCA connectors on one end and speaker plugs on the
other end with L (left), R (right), or C (center) markings.
• Surround speaker cables have orange RCA connectors on one end and speaker plugs
on the other end with L (left) or R (right) markings.
2. Orient the plug with its small knob up, so the plug slips easily into a notch on top of the
jack on the back of each speaker.
3. Insert the plug of each speaker cable fully into the jack on the rear of its respective
speaker.
4. Follow the instructions on page 13 to connect each cable to the corresponding jack on
the Acoustimass module.
Français
®
module
®
speakers, which use a plug-in type of cable connector.
speakers
®
Español
English
®
ページを印刷する