- ページ 12

ドリル Atlas Copco PHE 26 RAのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Atlas Copco PHE 26 RA 12 ページ。

Mounting the

1 Fit the gasket (2) to the motor housing (3).

gear housing

2 Fasten the gear housing (1) to the motor

housing (3) and fix it with screws (2,5+5

Nm).

3 Fit the gear lever (4) (mount it in

the "hammer" position, the pin must

grasp the elongated hole of the locking

slide).

Mounting the

1 Insert the spring (8) and the retaining

SDS-plus

disk (7).

Reception

2 Depress the retaining disk (7) and insert

the ball (6).

3 Fit the retaining ring (5) and the sliding

sleeve (4).

4 Depress the sliding sleeve and insert the

seal ring (3) into the pass.

5 Fit the spacer (2).

6 Push down the sliding sleeve and fit the

rubber (1).

Test run and

Carry out a test run and check for strange noises.

electrical

Carry out an electrical examination. (See chapter Electrical and Mechanical Test Instruction).

examination

Repair Instruction No. 174.3/95

1 2

3 4

PHE 26 RA

7 8

PAGE

1 5