- ページ 11
ドリル Atlas Copco PHE 26 RAのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Atlas Copco PHE 26 RA 12 ページ。
Assembling the
spindle
spindle is provided with service borings
(mounting the
for easy removing of the locking ring (7).
inner parts)
Older spindles must be exchanged for
new ones.
1 Push the O-rings (8) onto resp. into the
pressure sleeve (5).
2 Fit the brake disk (2), the O-ring (3), and
the pressure sleeve (5) to the plunger (4)
and insert them into the spindle (1).
3 Insert the washer (6) into the spindle until
on top of the O-ring.
4 Press the locking ring (7) with a used
cylinder into the spindle until the locking
ring engages. Visual check!
Assembling the
1 Mount the disk springs (1) with the
spindle
bulgings head-on (see illustration)
(mounting the
2 Mount the clutch (the ratchet (2) with
outer parts)
indentations against the toothing of the
spindle wheel (3)).
3 Fit the locking ring (4) and press it on
against the pressure of the disk springs.
4 Mount the locking slide (5) and the
retaining clip (6).
5 Mounting the rear thrust bearing (7):
- profile ring with damper-O-ring
- two compensating washers
- thrust bearing
- washer
6 Secure the rear thrust bearing (7) with the
special locking ring (8).
Mounting the
1 Fit the spindle (2) to the motor housing (4)
spindle
and fasten it with two screws (1) (6 Nm).
2 Push the ring gear (7) over the back gear
shaft (8) and let it engage in the locking
slide (3).
3 Push the planetary gear (6) onto the back
gear shaft and fit them into the ring
gear (7).
4 Push the straight pin (5) through the
locking slide (3) and insert it into the motor
housing (4).
From date of manufacture 01/96 the
Repair Instruction No. 174.3/95
1
2
1
1
2
5
PHE 26 RA
3
4
5
6 7
8
2
3 4
5
6
7
3
4
6
7
8
PAGE
11
11
8
1 2
1 3