- ページ 9
ドリル Atlas Copco PHE 26 RAのPDF 修理指示をオンラインで閲覧またはダウンロードできます。Atlas Copco PHE 26 RA 12 ページ。
ページを印刷するAssembling the
1 Grease the pinion reception (8).
extraction
2 Put the thrust piece (9) in the grease.
housing
Insert the thrust piece as shown in
illustration.
3 Insert the rear part (8) of the extraction
housing together with the armature into
the motor housing (7) and secure with
screws (5).
4 Fit the gasket (4) and apply some silicon
(10) to the area of the aspiration hole.
5 Fit the front part of the extraction housing
together with the end shield (2) to the
rear part (6) and secure with the screws
(1).
Assembling the
1 Insert the carbon brush holders (6).
electrical parts
2 Insert the carbon brushes (5) and hang up
the tension springs (4) with clasp.
3 Insert the AVS-rubber (2) and the guiding
rollers (3).
4 Mount the handle cover (1) on the motor
housing.
5 Insert the electrical parts in the handle
cover and connect them according to the
connection diagram.
housing. Cables must never be jammed
when assembling.
Assembling the
1 Insert the AVS-rubber (1).
handle
2 Fasten the handle cover (2) with screws.
3 Fasten the mains cable (4).
4 Fasten the strain relief (5).
5 Fasten the service cover (6) with screws.
After the high-voltage check, fit the
Softgrips (3).
Make sure the cables fit properly in the
Repair Instruction No. 174.3/95
1 2
3
1
black
blue
red
A1
E2
E1
A2
grey
2 1 3
1
PHE 26 RA
4
5
6
7
2
3
2
3
4
5 6 3
1
3
2
4 5 6
PAGE
9
5
6
7