- ページ 5

グラインダー Atlas Copco 8423031287のPDF 製品取扱説明書をオンラインで閲覧またはダウンロードできます。Atlas Copco 8423031287 12 ページ。 Die grinder

G2427 S180

Preparations before using the die grinder

Correct function of die grinder

WARNING Overspeed can result in serious injury or death

The maximum permissible speed as marked on the machine must not be

►

exceeded

Testing of the die grinder should only be carried out by professional techni-

cians. The technicians must be authorized to test this type of tool and to operate

a pneumatic system in accordance with national directives.

• The free speed of the machine shall be checked every day and whenever the

machine has been serviced. This check should be carried out with the grind-

ing equipment detached

• Use a pressure regulator to avoid excessive air pressure which may cause

overspeed

• Connections and air hose must be in good condition

Mounted wheel and carbide burr

WARNING Air under pressure can cause serious injury

Always shut off air supply, drain hose of air pressure and disconnect tool

►

from air supply when not in use, before making any adjustments to the

machine, e.g. changing accessories, or when making repairs

WARNING Wrong insert tool can burst and cause serious injury or

death

Use insert tool with max operating speed higher or equal to the airgrinder

►

speed

Do not use other insert tool than specified by the manufacturer (no cut-

►

ting off wheels or router bits).

• Use only recommended sizes and types of abrasives

• Do not use mounting wheels that are chipped or cracked, or may have been

dropped

• Correct mounting is necessary to prevent injury from broken mounted

wheels

• Ensure the shaft diameter of the accessory is correct for the size of collet

• Do not mix mm shanks with inch collets and vice versa

• Observe a min of 10 mm axial grip of the shank

Safety and operating instructions