- ページ 12

屋外用家具 ABSCO SHEDS ADGAZEBO63のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ABSCO SHEDS ADGAZEBO63 14 ページ。 Signature gazebo

GUTTERING

FRONT VIEW - NOTE: Gutter falls to left for illustrative purposes only.

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

8. The gutter needs fall to drive water to a specific

end. At the end you'd like the downpipe, mark

the underside of the gutter onto the beam.

This will be used as a reference when mounting

the gutter brackets RWG24.

Take the gutter down for now.

9. At the other end measure up another 10mm

from this reference line and make another mark

onto the beam at the point shown.

10. Take a string line and make a line from the

high to low point.

11. Align the bottom of the gutter bracket with

the marks and fasten to rear beam using rivets

FAST102.

• Place middle bracket at centre panel join.

• From there align with every 4th pan as shown.

12. Lift the gutter assembly and placed the rolled

top edge over the gutter bracket in the orientation

shown.

Roll the gutter around, make sure the front and

rear flashings go inside.

13. Lift so the bottom sits on the lower part of the

bracket.

Fold the tabs down by hand then rivet from below

as shown.

14. Rivet the gutter end stop to the front and rear

flashing.

Model: ADGAZEBO63

4/12/23

1.00