- ページ 11

ヘッドセット Bose AHX-32-0のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Bose AHX-32-0 36 ページ。 Bose aviation headset owner's guide

Figure 6

Pulling the cable assembly

straight out from the earcup

note the important markings for left (L) and right (R) above each ear-

cup. These markings indicate which ear each earcup is intended to

fit over.

Removing an attached boom microphone cable

1. Use a flat-tipped screwdriver to loosen the two screws at the

base of the boom microphone cable assembly.

2. Pull the cable assembly straight out from the earcup to which it

is attached (Figure 6).

CAUTION: Do not twist the boom microphone cable while discon-

necting it. Twisting can damage the connector pins.

Connector

Access

pins

cover

Cable

assembly

Before you attach the boom microphone, make sure that the cable

connector and its earcup connector are clean and free of debris.

1. Use a flat-tipped screwdriver to loosen the two screws on the

access cover near the bottom of the earcup where you want to

attach the boom microphone.

2. Remove the cover to reveal the connector pins on the earcup.

3. Carefully line up the connector to the small connector pins on

the panel (Figure 7 on page 12).

CAUTION: An improperly aligned connector will not make the con-

nections neccessary for proper operation, and may cause damage.

ETTING

OUR

EADSET

Connector

pins

EADY FOR

L for left