Bose AHX-32-0 Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Bose AHX-32-0. Bose AHX-32-0 36 pagina's. Bose aviation headset owner's guide
Pagina afdrukken
Figure 6
Pulling the cable assembly
straight out from the earcup
note the important markings for left (L) and right (R) above each ear-
cup. These markings indicate which ear each earcup is intended to
fit over.
Removing an attached boom microphone cable
1. Use a flat-tipped screwdriver to loosen the two screws at the
base of the boom microphone cable assembly.
2. Pull the cable assembly straight out from the earcup to which it
is attached (Figure 6).
CAUTION: Do not twist the boom microphone cable while discon-
necting it. Twisting can damage the connector pins.
Connector
Access
pins
cover
Cable
assembly
Attaching the boom microphone cable
Before you attach the boom microphone, make sure that the cable
connector and its earcup connector are clean and free of debris.
1. Use a flat-tipped screwdriver to loosen the two screws on the
access cover near the bottom of the earcup where you want to
attach the boom microphone.
2. Remove the cover to reveal the connector pins on the earcup.
3. Carefully line up the connector to the small connector pins on
the panel (Figure 7 on page 12).
CAUTION: An improperly aligned connector will not make the con-
nections neccessary for proper operation, and may cause damage.
G
Y
H
ETTING
OUR
EADSET
Connector
pins
R
U
EADY FOR
SE
L for left
11