- ページ 15

3Dプリンター Elegoo MARS 4 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Elegoo MARS 4 Series 20 ページ。
Elegoo MARS 4 Series にも：ユーザーマニュアル (20 ページ)

Bottom Wait After Lift:

When printing the bottom layer, the time diﬀerence between

the build platform starting stationary and starting to return to the printing surface

after lifting, the default setting is 0 seconds.

Bottom Wait Before Cure:

When printing the bottom layer, after the build platform

moves to the printing surface, the time diﬀerence between the build platform starting

stationary and the start of exposure, the default setting is 1 seconds.

Bottom Wait After Cure:

When printing the bottom layer, the time diﬀerence between

the end of the print exposure and the start of the build platform to leave the printing

surface, the default setting is 0 seconds.

Bottom Lift Distance:

During the bottom printing process, the distance that the build

platform leaves the printing surface each time, the default setting is 2+3mm.

Lifting Distance:

In the normal layer printing process, the distance that the build

platform leaves the printing surface each time, the default setting is 2+3mm.

Bottom Retract Distance:

During the bottom printing process, the retract distance of

the build platform, do not change if not necessary, the default setting is 3.5+1.5mm.

Retract Distance:

In the normal layer printing process, the retract distance of the

build platform, do not change if not necessary, the default setting is 3.5+1.5mm.

Bottom Lift Speed:

During the bottom printing process, the moving speed of the build

platform away from the printing surface each time, the default setting is 75+230mm/min.

Lifting Speed:

In the normal layer printing process, the moving speed of the build

platform away from the printing surface each time; the default setting

is 75+230mm/min.

Bottom Retract Speed:

During the bottom printing process, the moving speed of the

build platform is close to the printing surface; the default setting is 230+75mm/min.

Retract Speed:

In the normal layer printing, the moving speed of the build platform

is close to the printing surface; the default setting is 230+75mm/min.

Parameter Mode:

The default static mode allows the printer to print according to the

parameters set in the slicing software, or you can choose the dynamic mode, the

printer will dynamically adjust the printing parameters according to the complexity

of the model to improve the printing speed.