- ページ 17

3Dプリンター Elegoo MARS 4 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Elegoo MARS 4 Series 20 ページ。
Elegoo MARS 4 Series にも：ユーザーマニュアル (20 ページ)

FAQ

1. Model doesn't stick to the build platform

The bottom layer exposure time is too short, please add more time.

The model bottom layer has very small contact with the build platform,

please add a bottom raft.

Leveling is not well set and it will cause the ﬁrst layer too thick,

or one side is very thick while the other is very thin.

2. Model layer breakage

The printer is shaking during printing.

Release liner ﬁlm is very loose due to long-time usage and needs to be replaced.

Build platform or resin tank is not fastened.

3. Printing failure

If the model was not completely printed or failed, there might be some residues left

in the resin, which can be ﬁltered out with a funnel when you save the rest resin back

into its sealed bottle. If you don't ﬁlter out the residues, the build platform may cause

damage to the tempered glass or screen when you're printing next time. As to the

residual resin on the build platform, you can clean and wipe them up with tissues.