- ページ 4

潤滑システム DROPSA VIP4Tools CoaxialのPDF ユーザー・メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。DROPSA VIP4Tools Coaxial 11 ページ。

6. UNPACKING AND INSTALLING THE PANEL

6.1 UNPACKING

Once a suitable location has been found to install the unit, remove the panel from package. Check the unit has not been

damaged during transportation or storage. No particular disposal procedures are necessary as package materials are no

dangerous for health or environment. However, package should be disposed of in accordance with regulations that may

be in force in your area or state.

6.2 INSTALLING THE PANEL

To install the panel, use only the supplied bracket provided with two holes for screws Ø6mm (Ø 0.23 in.), see

Dimensions ch.12.

WARNING!

 In order to facilitate maintenance interventions, to avoid unnatural posture for personnel during

operation or the possibility of sustaining impacts, install the machine in a comfortable and easy-to-reach

location.

 Allow sufficient space for the installation, leaving minimum 100 mm (3.93 in.) around the unit.

 Do not install the unit in aggressive or explosive/inflammable environments or on vibrating surfaces.

6.3 INSTALLING MINI-PUMPS ON SUB-BASES

Mini-pumps are assembled to the sub-bases by means of two fixing screws. Be careful to correctly position o-rings

between mini-pumps and mixing bases, as shown in the figure below:

6.4 ASSEMBLY OF THE AIR-OIL MODULES

To assembly a new mixing element, proceed as follows:

1. Empty the reservoir.

2. Disconnect the unit from the air supply source and unscrew the fittings on the base.

3. Connect a new base and tighten the new element using the provided screws, paying attention to the alignment

and position of the o-rings.

4. Screw the fittings on the new base.

machine