- ページ 3
アクセサリー Ankom Daisy D200のPDF 交換をオンラインで閲覧またはダウンロードできます。Ankom Daisy D200 4 ページ。 Motor replacement
7.
Install the new 120v or 220v Motor. (The example image shows
a 220v Motor being installed)
a. Technician #1 mounts and holds the new motor in place on the
back of the instrument.
b. Technician #2 uses a Phillips screwdriver to secure the motor
with the three screws on the inside of the cabinet.
8.
Reattach the drive pulley.
a. Place the drive pulley back onto the center shaft inside the
cabinet.
b. Tighten the hex screw on the inside of the drive pulley using a
3/32 hex wrench.
9.
Reconnect the two drive belts.
a. Place a belt around each of the drive rollers.
b. Line the belts up with the bottom groove on the drive rollers
and pull the belts, one at a time, around the drive pulley. One
belt will be placed in the bottom groove and another will be
placed in the top groove of the drive pulley.
10.
220v Motor: Reconnect the two motor wires to the Terminal
Block Assembly.
a. Twist the wire ends to prevent fraying as they are reinserted
into their designated slots on the terminals.
b. Place the wire ends in their correct terminal blocks one at a
time. Using the small flat-blade screwdriver, screw the white
wire into the #1 gray terminal block and the red wire into the
#3 blue terminal block.
c. Gently pull each wire to make sure they are secure in the
terminal.
ANKOM Technology 2052 O'Neil Road Email: service@ankom.com Phone: 315-986-8090 Fax: 315-986-8091
Motor Replacement
D200/D200I
Service Procedure
Revised: 08/06/2014
Terminal #1
Terminal #3
001
pg. 3 of 4