Ankom Daisy D200 Değiştirme - Sayfa 3

Aksesuarlar Ankom Daisy D200 için çevrimiçi göz atın veya pdf Değiştirme indirin. Ankom Daisy D200 4 sayfaları. Motor replacement

Install the new 120v or 220v Motor. (The example image shows

a 220v Motor being installed)

a. Technician #1 mounts and holds the new motor in place on the

back of the instrument.

b. Technician #2 uses a Phillips screwdriver to secure the motor

with the three screws on the inside of the cabinet.

Reattach the drive pulley.

a. Place the drive pulley back onto the center shaft inside the

cabinet.

b. Tighten the hex screw on the inside of the drive pulley using a

3/32 hex wrench.

Reconnect the two drive belts.

a. Place a belt around each of the drive rollers.

b. Line the belts up with the bottom groove on the drive rollers

and pull the belts, one at a time, around the drive pulley. One

belt will be placed in the bottom groove and another will be

placed in the top groove of the drive pulley.

10.

220v Motor: Reconnect the two motor wires to the Terminal

Block Assembly.

a. Twist the wire ends to prevent fraying as they are reinserted

into their designated slots on the terminals.

b. Place the wire ends in their correct terminal blocks one at a

time. Using the small flat-blade screwdriver, screw the white

wire into the #1 gray terminal block and the red wire into the

#3 blue terminal block.

c. Gently pull each wire to make sure they are secure in the

terminal.

ANKOM Technology  2052 O'Neil Road  Email: [email protected]  Phone: 315-986-8090  Fax: 315-986-8091

Motor Replacement

D200/D200I

Service Procedure

Revised: 08/06/2014

Terminal #1

Terminal #3

001

pg. 3 of 4