- ページ 2
室内装飾品 Anova F1147のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Anova F1147 3 ページ。
Anova F1147 にも： 組み立て説明書 (2 ページ)
ページを印刷する
Locate the rubber feet and insert one in each of the two outside
7.
holes on the bottom of each of the table top supports.
Use the rubber mallet to set the feet if necessary.
8.
Locate the cross brace and position it in the center of the table top supports so that the mounting holes in the brace line up
with the mounting holes in the supports.
Place a flat washer on one of the 2 1/2" Phillips head screws and insert the screw through one of the table top mounting holes
and through the matching hole in the cross brace.
Place a flat washer on the screw and then tighten it finger tight with a nylock nut.
Repeat this process for the three remaining cross brace mounting holes.
Table Top Support
9.
Turn the table right side up.
10.
Level the table top while tightening all of the hardware.
11.
Move the table to the location where it will be used.
12.
After two weeks, retighten all of the hardware.
2
5/16" Flat Washer
Cross Brace
5/16" -18 Nylock Nut
Install Rubber Feet in
the two outside holes
5/16" Flat Washer
5/16 - 18 x 2 1/2"
Phillips Head Screw