- ページ 2

モニター 3M Dynapro ET 3170 Terminal Series BのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3M Dynapro ET 3170 Terminal Series B 4 ページ。 Desktop stand's installation: terminal and computers
3M Dynapro ET 3170 Terminal Series B にも：インストレーション・マニュアル (4 ページ), インストレーション・マニュアル (3 ページ), インストレーション・マニュアル (6 ページ), インストレーション・マニュアル (2 ページ)

3. Make the cutout and drill the holes.

4. Bring the power cable and the data cable connections

up to the cutout.

5. Place the bezel-mounted sealing gasket (supplied)

against the chassis of the ET unit so that the gasket

seals the gap between the panel and the unit.

Note: Depending on connector depth and cabinet

space, you may have to make your connections at this

point, before installing the unit in the cutout. If so,

skip to Step 10 and Step 11, then come back to Step 6.

6. Place the ET unit in the cutout. You may need

assistance at this point to hold it in place.

7. Attach the unit to the panel from the back using the

#10-32 screws that are supplied. Choose the ½ inch or

¾ inch screws supplied, whichever length is best for

the thickness of your panel.

Put a lock washer on each screw and then put a flat

washer on each screw (on top of the lock washer).

8. Gently tighten each screw (in a circular sequence)

9. With a torque screwdriver, tighten the screws, still in a

10. Connect cables.

11. Connect power to the unit.

3M Touch Systems Proprietary Information

Installing the NEMA 4X Panel Gasket

until some resistance is encountered.

circular sequence, to a torque of 12 inch-pounds. This

will take several passes, since each pass reduces the

previous torque setting.