3M Dynapro ET 3170 Terminal Series B Installationshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationshandbuch für Monitor 3M Dynapro ET 3170 Terminal Series B herunter. 3M Dynapro ET 3170 Terminal Series B 4 Seiten. Desktop stand's installation: terminal and computers
Auch für 3M Dynapro ET 3170 Terminal Series B: Installationshandbuch (4 seiten), Installationshandbuch (3 seiten), Installationshandbuch (6 seiten), Installationshandbuch (2 seiten)
Seite drucken
3. Make the cutout and drill the holes.
4. Bring the power cable and the data cable connections
up to the cutout.
5. Place the bezel-mounted sealing gasket (supplied)
against the chassis of the ET unit so that the gasket
seals the gap between the panel and the unit.
Note: Depending on connector depth and cabinet
space, you may have to make your connections at this
point, before installing the unit in the cutout. If so,
skip to Step 10 and Step 11, then come back to Step 6.
6. Place the ET unit in the cutout. You may need
assistance at this point to hold it in place.
7. Attach the unit to the panel from the back using the
#10-32 screws that are supplied. Choose the ½ inch or
¾ inch screws supplied, whichever length is best for
the thickness of your panel.
Put a lock washer on each screw and then put a flat
washer on each screw (on top of the lock washer).
8. Gently tighten each screw (in a circular sequence)
9. With a torque screwdriver, tighten the screws, still in a
10. Connect cables.
11. Connect power to the unit.
3M Touch Systems Proprietary Information
2
Installing the NEMA 4X Panel Gasket
until some resistance is encountered.
circular sequence, to a torque of 12 inch-pounds. This
will take several passes, since each pass reduces the
previous torque setting.