- ページ 5

セキュリティシステム DSC PC1550のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DSC PC1550 12 ページ。 4 digit master code
DSC PC1550 にも：取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (9 ページ), 取扱説明書 (17 ページ)

ページを印刷する

If the smoke detector is reset but goes into alarm again after the 90-second

delay, the fire alarm will sound again and the process described above will

repeat. A fire alarm will be transmitted to your monitoring station after 30 seconds

if it is not silenced by pressing the [#] Key.

Smoke detectors installed on your system may be reset after a false alarm using

the [*][4] command. To reset smoke detectors to normal, first clear all products of

combustion from the detectors. Press [*] then hold down the [4] key for several

seconds. If the detectors are clear of smoke, they will return to normal. If the

detectors still have smoke in them, the alarm will sound again. If the alarm

sounds again, first ensure that there is no threat of fire; you may then silence the

alarm and reset the smoke detectors.

An immediate fire alarm signal and transmission may be generated by holding

down the [F] key for 2 seconds.

Zone

Lights, when ON in the normal operating mode, indicate an open zone.

e.g. open door, window, etc.). Refer to zone chart on keypad door for zone

information.

Ready

light ON: system ready for arming.

Ready

light OFF: open zone. Must be closed or bypassed before arming.

Armed

light will come ON indicating system is armed. To arm: ensure "READY"

light is ON; enter [4 digit] access code to arm panel.

Memory

light ON means an alarm has occurred. To display zone that caused

alarm, press [*] then [3]. Zone light will come on indicating which zone caused

the alarm.

Bypass

light comes ON when you bypass a zone. To bypass a zone, press [*],

[1], [Access Code] and then the zone(s) you wish to Bypass. Enter 1 for zone

1....6 for zone 6. Press [#] to return to ready.

Trouble

light ON means there is a fault on the system. Press any key to silence

keypad beeping. Press [*] then [2] to display type of trouble:

ZONE LIGHT TROUBLE

1.......... Defective Stand-by Battery

2.......... AC Power Failure (see Note below)

3.......... Fuse Failure

4.......... Unsuccessful Communication Attempt with Monitoring Station