- ページ 5

セキュリティセンサー DAITEM 171-21XのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DAITEM 171-21X 8 ページ。 Infared motion detector
DAITEM 171-21X にも：インストレーション・マニュアル (18 ページ)

ページを印刷する

5. Installing the detector

5.1 Choosing the best place

IMPORTANT: make sure there is a distance of at least 2 meters between each product, except between two detectors.

The motion detector must be placed:

• inside the building,

• 2.20 m above ground level

• at right angles to the entrances to be protected (interior

detection works best when the intruder walks across the

detector's ﬁelds-of-view),

• directed towards the inside of the room to be protected,

• in such a way that the area it protects does not overlap

with that of another motion detector.

The motion detector must not be placed:

• in an area likely to receive direct sunlight or a very powerful

light source,

• opposite or above a source of heat,

• outside or in a breezy place,

• directly on to a metal wall or close to sources of

interference (electricity meters, etc.) or ventilation such as

air-conditioning grilles.

5.2 Fixing method

IMPORTANT: for reasons of security and to ensure long battery life, installation of the anti-tamper pin is compulsory. In case of

omission or incorrect insertion of the pin, the detector LED indicator lamp flashes continuously when the detector is fitted to its

bracket.

The detector can be ﬁxed to a wall

in 3 ways:

• on a swivel bracket,

• ﬂat against the wall,

• in a corner.

There is an anti-tamper pin for each

type of ﬁxing method:

• swivel bracket: pin n° 0,

• ﬂat: pin n° 1,

• in a corner: n° 2.

• Fixing the detector on a swivel bracket

1. Hold the back plate against the wall in the desired position and

mark where to drill the holes.

2. Drill the holes in the wall.

3. Insert the long screw via the back plate and fasten the plate to the

wall.

4. Put the back plate cover in place.

5. Assemble both parts of the swivel.

6. Insert the mounted swivel into the long screw.

7. Position the base of the motion detector (a picture of a man shows

the top of the detector).

8. Tighten the screws lightly in order to be able to adjust the direction

of the motion detector.

9. Place the motion detector on its base and turn it so that it is facing

the right way.

Long screw

Back plate

Back plate cover

RIGHT

WRONG

RIGHT

Order in which to assemble parts

Screw

Swivel

+ tightening

washer

Pictogram

Pin n° 0

for swivel bracket

fixing (factory-

mounted pin)

Pin n° 1

Pin n° 2

Selection of pins

Pozidriv 1

Pozidriv 2