- ページ 6
セキュリティセンサー DAITEM 171-21XのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DAITEM 171-21X 8 ページ。 Infared motion detector
DAITEM 171-21X にも： インストレーション・マニュアル (18 ページ)
ページを印刷するIMPORTANT: when fixing the movement detector at an angle or flat against the
wall, fix the label (provided in the sachet of accessories) on the reverse side of the
product in order to cover the opening to avoid insects getting through.
• Fixing the detector flat against the wall
1. Drill through the two pre-drilling holes in the base of the motion detector.
2. Place the base against the wall in the desired place in order to mark
where to drill the holes (a picture of a man indicates the top of the base).
3. Drill the holes in the wall and fix the base.
4. Remove the factory-positioned pin.
5. Detach pin n° 1 from the selection supplied.
6. Position the pin in the right place.
7. Place the motion detector on its base.
• Fixing the detector in a corner
1. Drill through the two pre-drilling holes in the base of the detector.
2. Place the base against the wall in the desired place in order to mark
where to drill the holes (a picture of a man indicates the top of the base).
3. Drill the holes in the wall and fix the base.
4. Remove the factory-positioned pin.
5. Detach pin n° 2 from the selection supplied.
6. Position the pin in the right place.
7. Place the motion detector on its base.
5.3 Directing and testing the detector
IMPORTANT: the control panel must be in installation mode to check the above.
The infrared detector has a test mode for
checking:
• the power supply: the LED indicator lamp
lights up when you press the test button to
confirm the battery is operating correctly,
• the detection area: the LED indicator lamp
lights up on detection,
• the radio link (see § on checking the radio
link in the control panel manual).
"beep, detector X,
group Y immediate
)
)
)
)
)
IMPORTANT: at the end of the test period, the detector automatically switches back to normal operating mode:
• detector inhibited for 90 sec. after detection,
• the test LED indicator lamp is no longer lit when movement is detected.
Checking the detection area:
• press on the test button: the detector switches to test mode for a period
of 90 sec.,
• walk across the detection area at right angles to the detector's fields-of-
view (see diagram): every time movement is detected the detector test
LED indicator lamp lights up.
If no movement is detected: change the way the detector is facing on its
swivel bracket, check there is no obstacle between the detection area and
the detector.
171-21X
175-21X
(or delayed
or combined)"
Si fixation en angle ou à plat contre un mur
For a fixing in a corner or flat against the wall
Si fixation en angle ou à plat contre un mur
For a fixing in a corner or flat against the wall
Pictogram
Pictogram
6
2
1
653563_A
Pre-drilled holes
2 fixing
screws
Pozidriv 1
Pin n° 1 for fixing
the detector flat
against the wall
Pre-drilled holes
2 fixing
screws
Pozidriv 1
90°
Pin n° 2 for fixing
the detector
in a corner
172-21X
173-21X