- ページ 8

アクセサリー Attero Tech AXON A4FLEXのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Attero Tech AXON A4FLEX 13 ページ。 Networked audio connectivity interface

2.2.2 - Independent VLAN Configuration

The Ethernet network ports can also be configured as

independent VLANs. This allows the A4FLEX to support

applications where the audio network and control network are run

in their own individual VLANs. "Ethernet 1" would always be the

audio connection while "Ethernet 2" would be the control network

connection.

6 - Independent VLAN Configuration

*Note: All Attero Tech products are tested using UTP network

cabling and it is recommended that UTP cabling be used when

installing them. STP cabling can be used for installation though

care must be taken not introduce grounding issues into the

system by doing so.

1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260)496-9668 ⁞ www.atterotech.com

2.3 – Audio I/O Connections

The A4FLEX features two dedicated audio inputs, two flexible I/O

that can be configured as audio inputs or outputs, and two

dedicated amplified outputs.

7 - Balanced Wiring Example

The audio inputs and outputs use a balanced connection. If

connecting to devices that have unbalanced connections, the

wiring should be done as follows:

8 - Unbalanced to Balanced Wiring Example

The amplified outputs are designed to drive low impedance 4 and

8 ohms speakers. The SPKR connections on the A4FLEX should be

wired direct to the speaker terminals.

NOTES:

* Make sure suitable speaker cable is used.

* The A4FLEX does not support bridging of the speaker outputs

Page 4