- ページ 9

試験装置 Attonic ARFS-2のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Attonic ARFS-2 13 ページ。 Arfs-series digital force gauge

■Explanation of a button setting function (1)

Various functional set up in button operation.

●Set up the function

① Change Peak Hold (PEAK) and Tracking (TRUCK)

② Check Memory (MO) Data and Elimination of all memory data

③ Set up Comparator Function (HI)

④ Set up Comparator Function (LO)

⑤ Change Measuring Unit (UN)

⑥ Set up Over Load (OV)

⑦ Set up Power Auto Off(AP)

⑧ Set up Number of Digits on display / NP setting (NP)

⑨ Reverse Digital Display

Power switch is turned ON while pressed the P-button.

(Becomes MEASUREMENT MODE)

(When there is no key 2-3minutes,a power supply is turned

off automatically)

Keep to push F button about 6 seconds, indicate by FU

(function). (Becomes SETTING MODE)

Preparations the various setting were completed.

The programming procedure after FU display

① Change Peak Hold (PEAK) and Tracking (TRUCK)

Change the Peak hold (PEAK) and change the tracking (TRUCK)

when pressed the D button. (Initial setting : TRACK)

Push F button

② Check Memory (MO) Data and Elimination of all memory data

"MO " in the upper right side of the display.Can be

confirmed the memory date.

when press the D button. (from M01 up to M50)

Elimination of all memory data should press the RESET

button. (Each data is not eliminable)

The display indicate MO 0 when data is eliminated. (Initial

setting : 0)

Push F button

③ Set up Comparator　Function (HI)

Set up the upper limit of comparator function Figure rising

by D-button and Digit rising by RESET-button. When not

using this function, setting to the 0. (Initial setting : 0)

↓

The memory data is advanced

↓

－８－

ATTONIC