Attonic ARFS-2 Operation Manual - Page 9
Browse online or download pdf Operation Manual for Test Equipment Attonic ARFS-2. Attonic ARFS-2 13 pages. Arfs-series digital force gauge
■Explanation of a button setting function (1)
Various functional set up in button operation.
●Set up the function
① Change Peak Hold (PEAK) and Tracking (TRUCK)
② Check Memory (MO) Data and Elimination of all memory data
③ Set up Comparator Function (HI)
④ Set up Comparator Function (LO)
⑤ Change Measuring Unit (UN)
⑥ Set up Over Load (OV)
⑦ Set up Power Auto Off(AP)
⑧ Set up Number of Digits on display / NP setting (NP)
⑨ Reverse Digital Display
Power switch is turned ON while pressed the P-button.
(Becomes MEASUREMENT MODE)
(When there is no key 2-3minutes,a power supply is turned
off automatically)
Keep to push F button about 6 seconds, indicate by FU
(function). (Becomes SETTING MODE)
Preparations the various setting were completed.
The programming procedure after FU display
① Change Peak Hold (PEAK) and Tracking (TRUCK)
Change the Peak hold (PEAK) and change the tracking (TRUCK)
when pressed the D button. (Initial setting : TRACK)
Push F button
② Check Memory (MO) Data and Elimination of all memory data
"MO " in the upper right side of the display.Can be
confirmed the memory date.
when press the D button. (from M01 up to M50)
Elimination of all memory data should press the RESET
button. (Each data is not eliminable)
The display indicate MO 0 when data is eliminated. (Initial
setting : 0)
Push F button
③ Set up Comparator Function (HI)
Set up the upper limit of comparator function Figure rising
by D-button and Digit rising by RESET-button. When not
using this function, setting to the 0. (Initial setting : 0)
↓
The memory data is advanced
↓
↓
-8-
ATTONIC