ページを印刷する
Airtug® /
/ 216-941-9781 / www.airtug.com
Assembly Instructions
Tools Needed For Assembly: Wire cutter, utility knife, 5/16" - 9/16" &
11/16" socket or wrench.
Assembly Note: All reference to "right" and "left" orientation is made
while standing behind the tug and looking forward from the operator
position.
Remove the shrink wrap. In addition to the tug and the handle, the
following parts are included:
1. One (1) Quart of Oil,
2. One (1) Gear Strut Strap,
3. Two (2) Zip Ties
4. Muffler Deflector
5. Spare Oil Drain Plug
Step 1: Install the handle all the way through the second "U"
bolt. Push the handle approximately 1 1/2" beyond the second
"U" bolt. If it appears the handle will not fit through the "U" bolt,
loosen the nuts below. This is a very close tolerance so the bolt
will not interfere with the caster wheel. Once the handle is
installed, tighten all 4 nuts securely.
Step 2: The throttle cable and transmission cable are zip tied to
the engine. While holding each cable separately, cut the zip tie
and unravel each cable towards the rear of the tug. Attach the
throttle cable to the right side of the handle using the fasteners
already in the handle with a 5/16" socket.
3