AIRTUG 10-S Instruções de montagem e funcionamento - Página 3

Procurar online ou descarregar pdf Instruções de montagem e funcionamento para Equipamento agrícola AIRTUG 10-S. AIRTUG 10-S 4 páginas.

Airtug® /

/ 216-941-9781 / www.airtug.com

Assembly Instructions

Tools Needed For Assembly: Wire cutter, utility knife, 5/16" - 9/16" &

11/16" socket or wrench.

Assembly Note: All reference to "right" and "left" orientation is made

while standing behind the tug and looking forward from the operator

position.

Remove the shrink wrap. In addition to the tug and the handle, the

following parts are included:

1. One (1) Quart of Oil,

2. One (1) Gear Strut Strap,

3. Two (2) Zip Ties

4. Mufﬂer Deﬂector

5. Spare Oil Drain Plug

Step 1: Install the handle all the way through the second "U"

bolt. Push the handle approximately 1 1/2" beyond the second

"U" bolt. If it appears the handle will not ﬁt through the "U" bolt,

loosen the nuts below. This is a very close tolerance so the bolt

will not interfere with the caster wheel. Once the handle is

installed, tighten all 4 nuts securely.

Step 2: The throttle cable and transmission cable are zip tied to

the engine. While holding each cable separately, cut the zip tie

and unravel each cable towards the rear of the tug. Attach the

throttle cable to the right side of the handle using the fasteners

already in the handle with a 5/16" socket.