- ページ 7

ドライヤー DAN DRYER BJORK 3010のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DAN DRYER BJORK 3010 10 ページ。
DAN DRYER BJORK 3010 にも：取付方法 (2 ページ)

ADJUSTMENT OF AIR SPEED AND TEMPERATURE

• Insert a flat notch through the hole in the bottom of the casing and place it in the

potentiomenter screw (see drawing below).

• Adjust the air speed and temperature by rotating the potentiomenter screw:

Clockwise to increase(+).

Counterclockwise to decrease (-).

Note: Do not overturn the adjustment!

SENSOR RANGE ADJUSTMENT

The sensor range is adjustable between 100mm og 230mm

Standard range 170mm ± 20mm

• Switch off the power, remove the (2) screws in the lower area, and remove the cover.

• Use a small Phillips screw driver or flat notch to adjust the sensoren on the VR-screw:

Clockwise: To increase sensor activation range (+)

Counterclockwise: To decrease sensor activation range (-)

• The sensor activation range should be adjusted to its environments,

e.g. light and distance to the bottom of the sink.

Note: Do not overturn the sensivity adjustment.