- ページ 9

計測機器 Danatronics ECHO 7 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Danatronics ECHO 7 Series 9 ページ。 Thickness gages

7. Changing the Parameter Settings

To change any parameter settings, press the F1 – Menu key from the Transducer selection

screen. Use the up and down arrow keys to select the Display, Initial Settings, or Measurements

option depending on the setting you wish to change and press the MENU/OK key. Use the arrow

keys to select any of the settings you wish to change. Once you select a parameter, use the

arrow keys to navigate the options. When finished, press the F1 – Back key. For more detailed

information on parameter settings, please refer to the ECHO Series Manual

Note: The default setups will not be erased when assigning a new Setup File

Adjusting waveform parameters:

If your Echo is equipped with the live waveform and datalogger, in the A-scan or waveform main

measurement mode, you can adjust the following parameters in real time: Initial gain I DB, Final

gain Fdb, slope, rectification, range, delay, MB Blank, IF Blank, C3 Blank, Echo WindowECHO 1

Detect, ECHO 2 Detct, Pulser voltage, ID, Alarm.

Simply press the right or left arrow keys to toggle to the parameter to be adjusted then use the up

or down arrow to adjust and F1 when done.

Ver: 2.0