Danatronics ECHO 7 Series Hızlı Başlangıç Kılavuzu - Sayfa 9
Ölçüm Cihazları Danatronics ECHO 7 Series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Danatronics ECHO 7 Series 9 sayfaları. Thickness gages
Sayfayı Yazdır
7. Changing the Parameter Settings
To change any parameter settings, press the F1 – Menu key from the Transducer selection
screen. Use the up and down arrow keys to select the Display, Initial Settings, or Measurements
option depending on the setting you wish to change and press the MENU/OK key. Use the arrow
keys to select any of the settings you wish to change. Once you select a parameter, use the
arrow keys to navigate the options. When finished, press the F1 – Back key. For more detailed
information on parameter settings, please refer to the ECHO Series Manual
Note: The default setups will not be erased when assigning a new Setup File
Adjusting waveform parameters:
If your Echo is equipped with the live waveform and datalogger, in the A-scan or waveform main
measurement mode, you can adjust the following parameters in real time: Initial gain I DB, Final
gain Fdb, slope, rectification, range, delay, MB Blank, IF Blank, C3 Blank, Echo WindowECHO 1
Detect, ECHO 2 Detct, Pulser voltage, ID, Alarm.
Simply press the right or left arrow keys to toggle to the parameter to be adjusted then use the up
or down arrow to adjust and F1 when done.
Ver: 2.0
9