- ページ 16

扇風機 Duco DucoBox FocusのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Duco DucoBox Focus 20 ページ。
Duco DucoBox Focus にも：ユーザーマニュアル (2 ページ), インストレーション・マニュアル (16 ページ), クイックスタート (4 ページ)

ENGLISH

Before activating air calibration mode:

• Close all windows and doors�

• Ensure that all duct openings in the DucoBox are fully closed and that the

DucoBox cover is closed!

• Avoid air leaks in the ventilation ducts�

• Set all window ventilators to the open position� Any Tronic ventilators will open

automatically�

Pull the plug out of the socket and wait a few seconds�

Put the plug back into the socket� The DucoBox will be configured automatically on

start-up� Calibration takes 30 seconds + 1 minute per connected control valve�

* Depending on the software version of the User controller / CO

08.B Checking

The steps set out below can be used to check whether flow rates have been set correctly�

Checking configured flow rate

Open the DucoBox cover�

Press 'HIGH' briefly� The DucoBox will remain in configuration mode for 30 min-

utes (as standard)�

Close the cover�

Wait at least one minute to allow the ventilation system to stabilise�

Measure the vents� If a flow rate differs from the desired output, this can be ad-

justed via the display menu or using the Duco Network Tool�

If you finish before the standard setting of 30 minutes, re-open the DucoBox cover

and press 'HIGH' again� Then replace the cover on the DucoBox�

L2000631 Installation guide for DucoBox Focus (Revision K | 13.07.2020)

/Humidity sensor�

open