Duco DucoBox Focus 설치 매뉴얼 - 페이지 16

{카테고리_이름} Duco DucoBox Focus에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duco DucoBox Focus 20 페이지.
Duco DucoBox Focus에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 설치 매뉴얼 (16 페이지), 빠른 시작 (4 페이지)

페이지 인쇄

ENGLISH

Before activating air calibration mode:

• Close all windows and doors�

• Ensure that all duct openings in the DucoBox are fully closed and that the

DucoBox cover is closed!

• Avoid air leaks in the ventilation ducts�

• Set all window ventilators to the open position� Any Tronic ventilators will open

automatically�

Pull the plug out of the socket and wait a few seconds�

Put the plug back into the socket� The DucoBox will be configured automatically on

start-up� Calibration takes 30 seconds + 1 minute per connected control valve�

* Depending on the software version of the User controller / CO

08.B Checking

The steps set out below can be used to check whether flow rates have been set correctly�

Checking configured flow rate

Open the DucoBox cover�

Press 'HIGH' briefly� The DucoBox will remain in configuration mode for 30 min-

utes (as standard)�

Close the cover�

Wait at least one minute to allow the ventilation system to stabilise�

Measure the vents� If a flow rate differs from the desired output, this can be ad-

justed via the display menu or using the Duco Network Tool�

If you finish before the standard setting of 30 minutes, re-open the DucoBox cover

and press 'HIGH' again� Then replace the cover on the DucoBox�

L2000631 Installation guide for DucoBox Focus (Revision K | 13.07.2020)

/Humidity sensor�

open