- ページ 12

スイッチ Concoa 537 SeriesのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Concoa 537 Series 20 ページ。 Autoswitch systems
Concoa 537 Series にも：据付・取扱説明書 (17 ページ)

Figure 10. Remote installation and match table.

CONNECTING A PERSONAL COMPUTER'S RS 232 CONNECTION

(SERIAL PORT) TO THE 529 5298 AND 529 5300 REMOTE ALARM

The following components are required to connect the secondary remote alarm to a personal computer.

one 529 5298 or 529 5300 remote alarm connected to at least one autoswitch

small flat-tip screwdriver (customer supplied)

cable (customer supplied)

9 pin or 25 pin "D" connector (customer supplied)

personal computer with a serial port (customer supplied)

The terminal view of the 529 5298 & 529 5300 remote alarm will look like the diagram shown in Figure 11. The

connections to the remote alarm will use the labeled terminal blocks shown in the diagram.

Move the power switch to the off position and disconnect the power source on the 529 5298 or 529 5300 remote

alarm before making any connections. Connect the cable to the "D" connector before attaching the cable to the

remote alarm. Once the "D" connector is attached to the cable, strip the end of each wire (at the opposite end of the

cable) about 1/8". Using the table below, insert the wire into the appropriate terminal. Tighten the terminal block

screw using a small flat-tip screwdriver. With the computer power off, connect the "D" connector to the computer.

Once the connections are made, connect the power source and move the power switch to the on position on the 529

5298 or 529 5300 remote alarm. The power LED's on the autoswitch and the remote alarm will illuminate. Turn

on the computer power.