- ページ 4

コントローラー anytronics Anyscene 1のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。anytronics Anyscene 1 6 ページ。 Memory unit

4. Data Connections

The DMX data connections are provided via one 8-pin RJ45 with the pinouts detailed

below. If XLR style outputs are required the installer should use the AS180 as this will

supply power along with the other connectors.

Upon request Anytronics can also supply the D2228 connector PCB to provide extra

connectors for programming only.

The maximum number of DMX receivers allowed along a single line is 32 devices without

the need for a buffer. If a DMX buffer is required within the system and an external DMX

source is also being used the Anyscene must all be linked with the external source and

then joined to the buffer for correct operation to the wider DMX line.

The DMX specification is based on the use of a single DMX source at one end of a twisted

pair with receiving equipment connected along the twisted pair, the final receiver must then

have a line termination resistor.

5.1. DMX Backup

With the power applied, the Anyscene 1 will power up and, if no input DMX data is detected

within 2 seconds, it will start to output DMX data from the last used scene. If another

source of DMX data is detected in the system, the Anyscene will instead remain dormant

in standby/receive mode capturing the current DMX data with start code zero from

channels 1 - 32.

Whilst in this mode, the yellow Data LED will remain illuminated if valid data is being

received at any of the decoded addresses. If the memory write protection switch is in the

ON position, this captured DMX data can be stored as scenes as per the programming

section of this document.

If the DMX source is then disconnected or fails, the yellow Data LED on the Anyscene will

be extinguished. After two seconds the Anyscene will start to retransmit the last received

DMX data, providing a standby or DMX backup feature. None of the mimic LEDs will be

illuminated in this mode as the output data corresponds to the last data received rather

than to the contents of any of the scene memories.

Units 5 & 6 Hillside Industrial Estate

London Road, Horndean,

Hampshire, PO8 0BL

Tel +44 (0)23 9259 9410

Fax +44(0)23 9259 8723

Page 4 of 6

AT1042 Issue 1

Anyscene 1 Operating

Instructions