- ページ 2
ゲートウェイ 3onedata GW11X8-8D (3IN1)-RJ45 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3onedata GW11X8-8D (3IN1)-RJ45 Series 4 ページ。 Modbus gateway
ページを印刷するFront view:
Rear view:
GW1108-8D(3IN1)-RJ45
GW1118-8D(3IN1)-RJ45
Side view:
Bottom view:
1.
Power indicator
2.
Running statues indicator
3.
Ethernet port Link/ACT indicator
4.
Serial port receive and transmits data indicator
5.
RS-232/485/422 serial port
6.
Power input terminal block
7.
Grounding screw
8.
DIP switch
9.
Console port
10. 10/100Base-T(X) Ethernet port
11. Rubber shock absorber pad
12. Screw holes for Wall Mounting Kit
【Dimension】
Unit: mm
【Power supply input】
The device provide DC power input, voltage input is the
three terminal form, plug type 3-pin spacing of 5.08mm
terminals, wherein the power input range of 12~48VDC. (V+,
FG, V-)
Notice:
- 2 -
1. Power ON operation: insert power cable's terminal block
into device's power port, and then connect power supply
plug to a power source.
2. Power OFF operation: unpin power plug, and then
disconnect the terminal block, please note operation
sequence.
【DIP switch】
The rear panel provides a 4-pin DIP switch to do function
configure (OFF is default factory). 1, 3 and 4 are reserved. 2
is recovery default factory. Please power off and power on
when you change the status of a DIP switch.
【Console port】
The device provides 1pcs procedure test port based on the
serial port. It adopts RJ45 interface, located on the front
panel, can configure related command through RJ45 to DB9
female cable.
【Communication connector】
10/100Base-T(X) Ethernet port
The pinout define of RJ45 port display as below, connect by
UTP or STP. The connect distance is no more than 100m.
100Mbps is used 120Ω of UTP 5, 10Mbps is used 120Ω of
UTP 3, 4, 5.
RJ 45 port support automatic MDI/MDI-X operation, connect
the
PC,
Server,
Converter
and
Corresponding connection in MDI. 1→3, 2→6, 3→1, 6→2
are used as cross wiring in the MDI-X port of Converter and
HUB. 10/100Base-T(X) are used in MDI/MDI-X, the define of
HUB
.Pin
1,2,3,6