- ページ 14

オーブン Duke 59 SeriesのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Duke 59 Series 20 ページ。 Ovens with “zp” control panel
Duke 59 Series にも：オーナーズマニュアル (20 ページ)

Installation and Operation of 5/9 Electric Convection Oven

B. GENERAL GUIDELINES FOR OPERATION

These guidelines are to assist you in obtaining the best performance from your oven:

•

Always pre-heat your oven before cooking by placing the temperature setting at the desired temperature.

The oven is pre-heated when the Indicator Light goes out.

•

Always use a lower temperature setting than that recommended for a standard conventional oven or range

oven. The general rule of thumb is to subtract 50 - 100°F from the standard oven recipe. Some experimentation

on your part may be necessary to achieve the optimum results with your food products.

NOTE: Cooking at higher temperatures will not reduce your cooking time! It will produce unsatisfactory

baking and roasting results.

•

You should begin checking the doneness of your food product in about half the time recommended for

the same recipe cooked in a standard oven. There is a Suggested Time and Temperature Chart on the next

page, which can serve as a guide. Keep in mind that your times may vary depending on the amount of

product being cooked in your oven. The best results are always achieved when a systematic record of times

and temperatures is kept for reference.

•

The oven will hold up to thirteen 18" x 26" (457mm x 660mm) sheet pans. Your product and pan height will

determine how many racks can be loaded.

NOTE: Do not place an empty sheet pan or aluminum foil on the bottom of the oven. This will disrupt the

airflow and cause uneven cooking results.

•

To minimize the shrinkage of roasted meats, place the meat directly on the racks and place a sheet pan one

half full of water in the bottom rack position. The water will keep the oven compartment more humid and

the meat juices will evaporate less.

•

Maintain equal loads when cooking more than one pan of product at a time. You may wish to weigh the

product to assure that the pan loads are equal. Smaller loads in one pan will cook at a different rate than

larger ones in another.

•

You may wish to experiment with leaving the oven OFF after pre-heating the oven and loading when

baking light products such as light cake batter or custard so the product will have time to set. Normally,

7-10 minutes with the oven OFF, then finishing with the oven ON, will keep the product from rippling or

being pushed by the fan.

•

When starting off with frozen product, you may wish to pre-heat your oven up to 100° F above the temperature

you are going to cook. Load the product and reset the temperature for the normal time.

•

For longer bulb life, do not leave the oven lights on when not viewing the product.

OPERATION INSTRUCTIONS - continued