- ページ 5

室内暖炉 Duluth Forge EL1346CのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Duluth Forge EL1346C 10 ページ。

INSTALLATION

NOTE: A 15Amp/120Volt alternating current (VAC) circuit is required. A dedi-

cated circuit is preferred but not essential in all cases. A dedicated circuit will be

required if, after installation, the circuit breaker trips or fuse blows on a regular

basis when the heater is operating. Additional appliances on the same circuit may

exceed the current rating of the circuit breaker.

WARNING: Ensure the electrical cord is not installed so that it is pinched or

against a sharp edge and ensure that the electrical cord is stored or secured

to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to

persons.

Construction and electrical outlet wiring must comply with local building codes

and other applicable regulations to reduce the risk of fire, electric shock and

injury to persons. Do not attempt to wire your own new outlets or circuits. To

reduce the risk of fire, electric shock or injury to persons, always use a licensed

electrician.

ELECTRIC FIREPLACE INSTALLATION

1. Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating

instruction section).

2. Plug the unit into a 15Amp/120VAC outlet. If the cord does not reach, an

extension cord may be used. The extension cord must be No.16 AWG minimum

size and rated no less than 1875 watts.

3. ADAPTERS ARE NOT ALLOWED CANADA

www.factorybuysdirect.com

M180017-1