ページを印刷する
INSTRUCTION MANUAL: DHP5
OPERATING INSTRUCTIONS
SETTING
CONTROL
PANEL
(continued)
PRESSING
Dulytek Equipment
www.dulytek.com
Fig. 5
9. Press Set button once more (Fig. 9) to record all control panel's
settings. The platens start heating, and the heating icons are now displayed
on the screen (Fig. 10).
Fig. 9
1. Wait until the platens heat up to the desired temperature (Fig. 11). Tip:
Once heating is finished, the heating icons are turned off.
2. Place the prepared material in the center of the bottom platen
3. Pump the jack handle
pumping until the desired pressure is reached. Release the handle.
4. Press TIMER button on the control panel to start the countdown (Fig.
12). The countdown is now shown on the lower line of the display.
5. Wait until the countdown ends and the press starts beeping.
6. Press TIMER button again to turn off the timer and stop beeping.
7. Turn the valve knob
the bottom platen
8. Remove the pressed material using heat resistant gloves or tools and
exercising extreme caution.
Email: [email protected]
(continued)
Fig. 6
Fig. 10
G
to move the bottom platen
F
counterclockwise to release the press and lower
.
C
Fig. 7
Fig. 11
C
up. Continue
D
© 2020 Dulytek
All rights reserved
PAGE 9
Fig. 8
Fig. 12
..
C