- ページ 6

メディア・コンバーター AudioControl LC6のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AudioControl LC6 16 ページ。 Six channel line output converter

Remote Subwoofer Level Control Input– This input allows you

to add an optional (sold-separately-not-included) remote that will allow

you to control the subwoofer output of your LC6 from your dashboard.

Pre-Amp Outputs: These RCA connectors should be connected to

the next component after the LC6, such as a signal processor, crossover

or amplifier. Do not connect any speakers directly to your LC6 or to any

home appliances, like your microwave.

Level Controls: These knobs allow you to adjust the signal level

from your source unit to match that of your after-market amplifiers.

Because they are amplified, most factory-installed source units have

relatively high signal voltage output, which will require you to decrease

the signal level.

UNDER THE COVERS

1. Signal Sense Settings: This allows you to select how much speaker-

level signal is necessary to turn on your LC6. The shipped-from-the-

factory setting of "NORMAL" is fine for most systems. However should

your system put out an abnormally low signal level, you may wish to

change the jumper to the lower setting.

2. Ground Isolation Selector: Occasionally alternator noise may

appear in a system because the source unit and amplifier are using

different grounding schemes. To help in this situation, we have provided

alternative grounding connections. Make sure your system is turned

OFF before you move these jumpers.

Figure 3: Inside view of LC6

Factory Settings

Ground Isolation

Autosensing Voltage

Weather

page 6

Shipped

Isolated

Normal

Rainy

Options

200ohm or Ground

Low

Overcast