AudioControl LC6 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AudioControl LC6. AudioControl LC6 16 pagina's. Six channel line output converter

Pagina afdrukken

Remote Subwoofer Level Control Input– This input allows you
to add an optional (sold-separately-not-included) remote that will allow
you to control the subwoofer output of your LC6 from your dashboard.
ž
Pre-Amp Outputs: These RCA connectors should be connected to
the next component after the LC6, such as a signal processor, crossover
or amplifier. Do not connect any speakers directly to your LC6 or to any
home appliances, like your microwave.
Ÿ
Level Controls: These knobs allow you to adjust the signal level
from your source unit to match that of your after-market amplifiers.
Because they are amplified, most factory-installed source units have
relatively high signal voltage output, which will require you to decrease
the signal level.
UNDER THE COVERS
1. Signal Sense Settings: This allows you to select how much speaker-
level signal is necessary to turn on your LC6. The shipped-from-the-
factory setting of "NORMAL" is fine for most systems. However should
your system put out an abnormally low signal level, you may wish to
change the jumper to the lower setting.
2. Ground Isolation Selector: Occasionally alternator noise may
appear in a system because the source unit and amplifier are using
different grounding schemes. To help in this situation, we have provided
alternative grounding connections. Make sure your system is turned
OFF before you move these jumpers.
Figure 3: Inside view of LC6

Factory Settings

Ground Isolation
Autosensing Voltage
Weather
page 6
Shipped
Isolated
Normal
Rainy
—
–
Options
200ohm or Ground
Low
Overcast